Fence Services
Fence Cost in Chester County, PA: Price Ranges by Type and Size
Most Chester County homeowners spend somewhere between a few thousand dollars for a short chain link run and well over $15,000 for a large vinyl or aluminum enclosure. The ranges below are rough local estimates to help you budget. Your real number depends on your yard, your township's rules and the installer's quote.
- No-cost request
- Matched by ZIP code
- Chester County, PA
01
Installed price by fence type
These are typical installed ranges per linear foot for residential work around the county, including posts, footings and labor but usually not gates, permits or removal of an old fence. Treat them as a starting point for budgeting, not a promise of any specific price.
| Fence type | Typical installed cost per foot | Notes |
|---|---|---|
| Galvanized chain link, 4 ft | About $15–$30 | Lowest cost; black coated adds roughly 20–40% |
| Split rail, 2–3 rail | About $15–$35 | Welded wire mesh for pets adds a few dollars per foot |
| Pressure-treated wood privacy, 6 ft | About $28–$50 | Stain or sealer typically extra |
| Cedar privacy, 6 ft | About $38–$65 | Board-on-board and shadowbox run higher |
| Vinyl privacy, 6 ft | About $38–$70 | Woodgrain and colors cost more than white |
| Ornamental aluminum, 4–5 ft | About $38–$75 | Commercial-grade and pool-code panels cost more |
02
What a project costs by yard size
Linear footage drives most of the bill, so measure your planned fence line before you request quotes. A small borough backyard in Phoenixville or West Chester might need only 80 to 120 feet. A typical quarter- to half-acre subdivision yard in Exton, Downingtown or West Goshen often lands between 150 and 250 feet. Larger township parcels around Chester Springs, Unionville or Oxford can easily exceed 400 feet.
| Fence length | Chain link | Wood privacy | Vinyl privacy | Aluminum |
|---|---|---|---|---|
| 100 ft | $1,500–$3,000 | $2,800–$5,000 | $3,800–$7,000 | $3,800–$7,500 |
| 150 ft | $2,250–$4,500 | $4,200–$7,500 | $5,700–$10,500 | $5,700–$11,250 |
| 200 ft | $3,000–$6,000 | $5,600–$10,000 | $7,600–$14,000 | $7,600–$15,000 |
| 300 ft | $4,500–$9,000 | $8,400–$15,000 | $11,400–$21,000 | $11,400–$22,500 |
03
Gates, removal and other add-ons
The per-foot price rarely tells the whole story. Gates are priced separately, and a wide double drive gate with reinforced posts can cost as much as a dozen feet of fence. Ask for each line item in writing so you can compare quotes fairly.
- Single walk gates: often a few hundred dollars to $800 or more
- Double drive gates: often $800 to $2,500 depending on material
- Old fence tear-out and haul-away: commonly $3–$8 per foot
- Self-closing hinges and magnetic latches for pool gates
- Core drilling into rock or concrete for posts
- Survey or pin location if property lines are unclear
Ready for a fence quote?
Send one short request and a participating local installer who covers your ZIP will reach out.
04
Local factors that push the price up
Chester County ground is rarely simple. Limestone in the Chester Valley around Exton, Malvern and Paoli, schist and fieldstone in the hills near West Chester and Kennett Square, and heavy clay in many subdivisions can all slow digging. Rocky holes may require core drilling or extra labor. Steep or rolling yards need stepped or racked panels, which takes more time to lay out.
Access matters too. Tight borough lots with no side yard often mean hand-digging and carrying materials by hand. Wooded lots may need brush clearing along the fence line first. Permit fees, HOA approval and historic review don't usually add much cost directly, but they can delay start dates during the busy spring season, when prices also tend to be firmest.
05
Ways to keep your fence budget in check
You can lower the total without cutting corners on the parts that matter most, like post depth and gate hardware.
- Fence only the areas you truly need, not the full lot line
- Mix materials: privacy near the patio, split rail elsewhere
- Choose four-foot heights where privacy isn't the goal
- Pick standard white vinyl over specialty colors
- Ask about off-season scheduling in late fall or winter
- Remove an old fence yourself if your installer agrees
06
Long-term cost, not just day one
A wood fence may cost less to install, but staining every two to four years and replacing boards adds up over 15 years. Vinyl and aluminum cost more upfront but usually only need occasional washing, so their lifetime cost can end up close to or below wood. Chain link is the lowest-maintenance budget option but offers little privacy. Think about how long you plan to stay in the home when you weigh the numbers.
Questions
Frequently asked questions
Go deeper
Related fence services
Vinyl Fence
Low-maintenance PVC privacy, semi-privacy and picket fences that never need staining.
Learn moreWood Fence
Cedar and pressure-treated pine fences in privacy, shadowbox, picket and board-on-board styles.
Learn moreAluminum Fence
Ornamental black aluminum that looks like wrought iron, keeps views open and won't rust.
Learn more
Get started
Ready to get your project started?
Share a few details and a participating contractor who serves your area will follow up about an estimate.